The introduction of the forged short hose end.

For the forged short hose end,there are 5 different size you can choose, as the bellow pic show:
For AN8, the material is Aluminum, item size is 0.16 x 2.7 x 2.2 inches (LxWxH)
The type is elbow and Weld,and the item weight is 0.16 Pounds.

About the craft:
1.Weld-free construction ,which gives better fluid flow and integrity over the normal brazed together hose ends.Swivel fittings are easy to use and don’t require special equipment. We normally recommend a bit of assembly lube to help prevent any galling.
2.fittings are made of lightweight aluminum alloy 6061-T6 material for strong strength and good durability.
3.Black anodized for great appearance and anti-corrosion, superior thread strength. Max Working Pressure: 1000psi. Working Temperature Range: -65℉ to 252℉ (-53℃ to 122℃). Can be suitable for competition applications where reduced weight is needed.
About the function:
1.The swivel hose end is widely used in oil/ fuel/ water/ fluid/ airline etc. Connect oil gas line, braided fuel line ,clutch hose,turbo line etc full flow swivel hose ends swivel 360° to allow for a quick alignment of the hose after assembly.Swivel hose end can be reused
How to connect the hose end?
Using 4an, 6an, 8an, and 12an sizes.
Running air, oil, coolant, and power steering fluid with these and braided stainless hose.

Quit debating brands, this one for fittings.

For install a solid/thin tape on the hose for keeping the fray in check during cutting with a die grinder or Dremel cut wheel.
Blow out the hose with compressed air there will be rubber bits in it.
A bit of water based assembly lube helps the fitting parts together on the hose end.
Hope the forged short hose end can benifit for you!

Post time: May-20-2022